**PLEASE NOTE: Because of the size (length or weight) of this product, it does not qualify for our $75 Free Shipping Offer. Shipping charges will be calculated at checkout for this item.

The J2 Lasher from GMP can lash single or multiple aerial cable bundles up to 3 inches in diameter on a suspension strand of 1/4 inch to 7/16 inches. The J2 has an all-range tensioning device to optimize strand traction and high strength front and rear gates for tighter cable lashing. The J2 features a built-in mechanical brake to prevent unintended reversal and an automatic drum lock for easy span transfer.

Features:

Consists of a rotating drum supported on a carriage that provides the mounting for a driving mechanism, cable lifters, cable and strand rollers

Fast setup procedure, quick coil loading, and automatic drum lock for easy span transfers and smooth forward travel

J2 Lashers make overlashing easy. Just push down on the strand roller knob, rotate it a quarter turn and you can lash additional cables together on previously lashed cable

Positive internal gear to gear mechanism has no chains or belts to stretch, slip or break

Constructed with heat-treated, plated steel, stainless steel, brass and aluminum components. Contains sealed and oiless bearings to minimize maintenance and assure durability

Pre-drilled and tapped at the factory for mounting of the lasher guard or “halo”. For use when lashing in overgrown areas.

The J2 and every GMP lasher is fully serviceable to “good-as-new” specifications at our factory and at factory-trained service locations around the globe

The lasher is furnished with a rugged lightweight storage chest with corrosion resistant hardware, recessed latches and a moisture-proof, tongue-in-groove design for maximum protection when not in use

Supplied with a 6 ft. bridle rope assembly and snap hooks, and an information and operation manual

Specifications:

Will lash any single or multiple aerial cables up to 3 in. (76 mm) diameter across on any suspension strand from 1/4 in. (6 mm) to 7/16 in. (11 mm). A factory modification will allow the lasher to accommodate 1/2 in. (12.7 mm) strand if necessary

Each of two recessed magazines will hold a 1200 ft. coil of .045 in. (365 m of 1.1 mm wire) lashing wire (or 450 ft. of .065 in.). The Lashing Wire is fully recessed and covered by a gate

Kit Includes: